Replacement Friction Rotors for KoBra-Brake System
Replacement Friction Rotors for Kobra-Brake System
Our KoBra-Brake System is equipped with two-piece brake discs (alloy pot + friction rotors)
If the rotors are worn (no slots left or cracks through the outer diameter) you have to replace it.
Here in the article you can get all the available options of replacement rotors. We deliver a set for one axle (1x LH and 1x RH rotor incl. the fitting kit / bobbins. Normally you can continue with the alloy-pot that exists.
The following variants are used:
a) 295mm-Rotors
Use: KoBra 2 with 2pot-Standard-Caliper front for Elise, Exige and 2-Eleven using 4Zyl-Powertrain (incl. Fitting)
b) 308mm-Rotors
Use: Lotus Big Brake Kit with 4Pot-AP-Caliper as a replacemnt for the Standard-Rotor frontfor Elise, Exige and 2-Eleven using 4Zyl-Powertrain (incl. Bobbin-Kit)
c) 313mm-Rotors
Use: KoBra 4 and KoBra 4-2 with Komo-Tec-Caliper front and rear for Elise, Exige and 2-Eleven using 4Zyl-Powertrain (incl. Bobbin-Kit). Attention: Rotors come "dyno-bedded"!
e) 343mm-Rotors FLOATED
Use: KoBra 4-4 FLOATED with 4Pot-AP-Standard-Caliper front and rear for Exige V6 Range and 3-Eleven (incl. Fitting)
f) 362mm-Rotors
Use: KoBra 4 and KoBra 4-4 with 4Pot-AP-Standard-Caliper front for Evora (or Evora 400 rear, incl. Fitting)
g) 378mm-Rotors FLOATED
Use: KoBra 4-4 FLOATED with 4Pot-AP-Standard-Caliper front for Evora 400 Range (incl. Fitting)
Hints:
Please take car of the driving in periode (except 313mm-dyno-bedded) to be sure that everything is running well and to avoid faiding!
Assembly requires technical knowledge!
Suitable accessories
